Retrofit Square Base Flashing
DETAILS:
•simple solution to flashing a penetration through a metal roof that requires a wrap-around installation
•wraps easily around existing or hard to reach penetrations
•has clearly marked diameters on each... Read More
•simple solution to flashing a penetration through a metal roof that requires a wrap-around installation
•wraps easily around existing or hard to reach penetrations
•has clearly marked diameters on each... Read More
$17.85
SKU
MBARF
DETAILS:
- simple solution to flashing a penetration through a metal roof that requires a wrap-around installation
- wraps easily around existing or hard to reach penetrations
- has clearly marked diameters on each flashing
- marked dimensions also allow for easy sizing to fit each individual application
- makes installation simple by using easily installed snap rivets; a cable tie is also supplied to reinforce the seal
- snaps together in seconds and does not require any special tools or accessories
- the aluminum base on the upper lip is corrosion resistant and allows the flashing to conform to any panel configuration and/or roof pitch
- available in EPDM or orange silicone, both flexible materials, and both resistant to ultraviolet rays, cracking & weathering
INSTALLATION INSTRUCTIONS:
1. | choose the appropriate retrofit Master Flash® |
2. | trim the opening to about 20% smaller than the pipe diameter |
3. | wrap the retrofit around the pipe and install all snap rivets to seal the flange |
4. | press the Master Flash® down, bending it to conform to the roof profile or roof irregularities |
5. | using a blunt tool will help press the flashing into tight roof angles |
6. | apply a silicone sealant between the Master Flash® base & the roof |
7. | use fasteners to complete the sealing |
8. | for UPC installation, fastener spacing may not exceed 1 1/2" |
9. | install the supplied cable tie at the upper-most part of the retrofit Master Flash® & apply sealant to any gaps |
TECHNICAL DATA:
Write Your Own Review